Bofeng - A leading Rapid Prototyping Service Company       

How to do the quick sample more perfect

by:Bofeng     2020-11-09
Rapid prototype is the first step to verify the product feasibility, later also can advance the investigation visit, so many companies in new product development will play a hand-board model first, however, rapid sample processing is a knowledge, if not careful, can appear a lot of problems, so how to make their own rapid sample processing and do a better job is very important

< br />

1, first of all, to confirm what is their needs, before looking for a quick sample processing is the quick sample processing has a certain understanding, know what they want with planks. Only when your heart is very understand, in hand, to achieve the best;

2, his heart know this is the first thing to do, and how to make fast samples of their products to have a certain understanding, so at this time you can find on the Internet about this aspect of knowledge, this is has great benefits for the panel processing, so if you want to make his hand had a very good effect, it is necessary;

3, finally have a good communication with processing personnel, this also is necessary. Because the hand of the company's staff, they must have a general processing concept, it is hard to change. So in hand, can put your own ideas to tell them, so they would know you what to do with planks.

fast sample is the first step to verify the product feasibility, is the most direct and effective way to find out product design defect, until fast samples are no problem to open mold as the basis. Usually also need to use silica gel complex mode or low-pressure perfusion technique to make a small batch trial production, investment, and even inspection product assembly difficulty level when mass production in the future. So, it is very important to fast samples are processed, should spend some of idea on it.

< br />

< br />

Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...
We will get back to you ASAP