Silicone compound die - — Medium and small batch production
silicon film coating is the first step to verify the product feasibility, later also can advance the investigation visit, so many companies in new product development will play a hand-board model first, however, silicon coated processing is a knowledge, if not careful, can appear a lot of problems, so how to make their own silicone coated processing do better is very important
< br />
1, first of all, to confirm what is their needs, before looking for silicone coated processing is the silicone coated processing has a certain understanding, know what they want with planks. Only when your heart is very understand, in hand, to achieve the best;2, his heart know this is the first thing to do, and how to make fast samples of their products to have a certain understanding, so at this time you can find on the Internet about this aspect of knowledge, this is has great benefits for silicone coated processing, so if you want to let oneself of the silicone coated with good effect, it is necessary; 3, finally have a good communication with processing personnel, this also is necessary. Because the hand of the company's staff, they must have a general processing concept, it is hard to change. So in the production of silicone coated, can put your own ideas to tell them, so they would know you what want to do the silicone coated effect. silicon film coating is the first step to verify the product feasibility, is the most direct and effective way to find out product design defect, until fast samples are no problem to open mold as the basis. Usually also need to use silica gel complex mode or low-pressure perfusion technique to make a small batch trial production, investment, and even inspection product assembly difficulty level when mass production in the future. So, silicone coated processing production is very important, should spend some of idea on it.